Used to assist in lubricating mechanical keyboard switches. Compatible with Cherry MX and MX clones. Holds switch bases and stems. 11 deg incline. Room for 50 switches.
Print upside down so no supports required.
Updated 1/7/2018 : Made holes for stems slightly bigger at 4.25mm. If the dimensional accuracy of your printer is off and makes geometry smaller than it's supposed to be then use a 4mm drill to ream the holes to the correct size. Modified the center support wall so that it doesn't touch the surface the lube station is sitting on. Added small 2mm feet in each corner so as to slightly elevate the lube station. Both the change to the center support wall and the addition of the feet is meant to alleviate stability problems introduced by warping causing the lube station to rock
| Lube_Station.stl | 1.9MB | |
| Lube_Station.stp | 1.5MB |
