Maxim-al Clamp (Kant Twist Style) 3D Printer Model
The file 'Maxim-al Clamp (Kant Twist Style) 3D Printer Model' is (stl) file type, size is 1.1MB.
The file 'Maxim-al Clamp (Kant Twist Style) 3D Printer Model' is (stl) file type, size is 1.1MB.
Surprisingly sturdy 3d-printed clamp based on the Kant Twist design, no externally purchased screws/nuts required.
Most of the parts can be printed without any supports, minus the Screw Nut & the Screw Cap. You'll need 6x of the little Pin Clip Rings.
Clamp as though the maxim of your action became a universal law.
| Maxim-Al_Clamp_v1_-_Jaw_Pin.stl | 80.7KB | |
| Maxim-Al_Clamp_v1_-_Lower_Jaw_Cap.stl | 51.4KB | |
| Maxim-Al_Clamp_v1_-_Lower_Jaw_Left.stl | 63.7KB | |
| Maxim-Al_Clamp_v1_-_Lower_Jaw_Right.stl | 63.7KB | |
| Maxim-Al_Clamp_v1_-_Pin_Clip_Ring.stl | 87.3KB | |
| Maxim-Al_Clamp_v1_-_Screw.stl | 926.4KB | |
| Maxim-Al_Clamp_v1_-_Screw_Cap.stl | 242.7KB | |
| Maxim-Al_Clamp_v1_-_Screw_Nut.stl | 1.4MB | |
| Maxim-Al_Clamp_v1_-_Upper_Jaw_Cap.stl | 61.6KB | |
| Maxim-Al_Clamp_v1_-_Upper_Jaw_Left.stl | 88.8KB | |
| Maxim-Al_Clamp_v1_-_Upper_Jaw_Left_Plain.stl | 49.7KB | |
| Maxim-Al_Clamp_v1_-_Upper_Jaw_Right.stl | 49.7KB |
