The file 'Master Cylinder Cap For Pressure Bleeding – With Schrader Air Valve Fitting. Fits All 50mm ID With 3 Tabs – 350Z, BRZ/GT86 3D Printer Model' is (stl) file type, size is 199.3KB.
Master Cylinder Cap for Pressure Bleeding your Brake Calipers.
Should fit all caps with 3 locking tabs and 50mm ID.
Will need to cut rubber gasket material for a proper seal - 49mm OD, 2-3mm thick. Adjust thickness until you get a proper seal. I used a 2mm and a 1mm for a tight seal.
Just connect a simple tire pump, set it at 15PSI and open the bleed nipples.
Ensure fluid level stays above minimum mark.
I ran the tank from Max to Min through each nipple on my Brembo Calipers.
| Brake_Bleeder_Cap_V2.stl | 509.6KB |
