I'm a fan of minimalist organizer, especially a game like this that will have continually released context. So I present this organizer. This fits all the currently released content in the base box. However, I knew with more expansions coming I knew I'd need more room, so I added an organizer for Rise of Red Skull. I currently have all the heroes and attributes in the base game and all the scenarios, side schemes, and campaign content in the expansion box.

Your print bed size or your desire to glue will determine how many of what type of the card holder you'd need.

• Larger bed: Print 2 copies of the Card Holder (full).
• Smaller bed (less than 280mm): You need to decide if you print 4 Card Holder (half) or 4 Card Holder (short). The only difference between the half and the short is the end wall. With the half you probably would want to clue or connect the two pieces. This is what I did personally (using spare filament and a soldering iron), but you can decide your best method.

The Token Box, Token Box Lid, and Dial Bin are remixes. I had to decrease the size slightly to fight in my new design.
Status Holder is also a remix. I decreased the size slightly to fit within the inner-dimensions of my card holders (which was about 1mm smaller). Because of this I'm unsure if they'll fit sleeved cards. I don't sleeve the Status cards.

Note for sleeves: I fit the side of the boxes to accommodate my sleeves and card dividers (Ultimate Guard). However, because the width of the Base Box was different than the Rise of Red Skull, I had to decrease the width of the boxes slightly. They still fit my card dividers, but it is 1mm more snug. So before printing, make sure your sleeves will fit with this box.
Inner-dimensions of boxes:
Base - 96mm
Rise of Red Skull - 95mm