Martian 2 220mm Lightbar Buzzer Receiver Holder 3D Printer Model
The file 'Martian 2 220mm Lightbar Buzzer Receiver Holder 3D Printer Model' is (stl,dae) file type, size is 31.0KB.
The file 'Martian 2 220mm Lightbar Buzzer Receiver Holder 3D Printer Model' is (stl,dae) file type, size is 31.0KB.
This is a lightbar holder with a receiver holder. I designed this to work with the Matek WS2812B Led Board with Buzzer and also a d4r receiver. The design allows it to be seurly mounted around the rear posts. I put some double sided tape between this and the frame and also held it down tighter with a able tie. You need to put your own holes through for the lightbar wires .... i tried to print in the hole but it is a better finish if you just make your own hole with a dremel. http://www.banggood.com/Matek-WS2812B-LED-Board-With-5V-Buzzer-For-Naze-32-Skyline-32-Flight-Controller-p-991715.html
The centre spacing for the middle of the two holes is the critical part its 32mm
| Martian_2_220mm_Buzzer_Lightbar_D4rii_Holder2.stl | 25.5KB | |
| Martian_2_220mm_Buzzer_Lightbar_D4rii_Holder2_fixed.stl | 36.9KB | |
| Martian_2_220mm_Buzzer_Lightbar_D4rii_Holder_vvVVvv.dae | 94.5KB |
