Mars Base Inside Victoria Crater 3D Printer Model
The file 'Mars Base Inside Victoria Crater 3D Printer Model' is (stl) file type, size is 23.8MB.
The file 'Mars Base Inside Victoria Crater 3D Printer Model' is (stl) file type, size is 23.8MB.
This is my interpretation of a martian base for human living and research.
It is intended to be built inside the Victoria Crater. This crater has a relatively small size and it has a flat surface inside wich makes it good for protection and construction.
The kit/base comes with:
Observation and research room
Water and supplies room
Common room
Oxygen and gas station
Transportation area with 2 vehicles.
Sanitary Area
Entertainment from earth (TV Shows) and Fitness room
Temporary/Emergency room
Energy area
Solar panels
Vehicle
Victoria Crater (only printable if scaled)
The kit has some moving parts.
| b2.stl | 5.1MB | |
| b3.stl | 1.2MB | |
| energy.stl | 1.5MB | |
| main_room.stl | 4.1MB | |
| multi_room.stl | 778.8KB | |
| oxygen_c.stl | 11.7MB | |
| solar.stl | 569.5KB | |
| trans_area.stl | 4.2MB | |
| tunels.stl | 4.0MB | |
| vehicle.stl | 13.3MB | |
| victoria_crater.stl | 12.3MB |
