Turn a carpenters folding rule or metal rulers into a marking gauge / depth stop. By tightening the lever the position of the ruler can be fixed.
Printed in place.
Best printed flat - as designed. Supports are required only towards printing bed, but no inner support. After printing the lever might be sticky. To loosen it gently slide e.g. a flat knife between lever and housing.
Design updated to support thin metal rulers. Don't tighten lever too much, otherwise ruler might cut into clamp.
Updates:
Have fun!
| RulerMarkingGauge.scad | 8.6KB | |
| RulerMarkingGauge.stl | 487.7KB | |
| RulerMarkingGauge_fence20x20.stl | 489.7KB | |
| RulerMarkingGauge_FoldingRulder_45deg.stl | 585.1KB | |
| RulerMarkingGauge_FoldingRuler_45deg.stl | 583.9KB | |
| RulerMarkingGauge_FullFoldingRuler.stl | 489.7KB | |
| RulerMarkingGauge_MetalRuler_13x0.5mm.stl | 493.7KB | |
| RulerMarkingGauge_MetalRuler_13x0.5mm_45deg.stl | 588.6KB | |
| RulerMarkingGauge_MetalRuler_30.6x1.7mm.stl | 496.0KB | |
| RulerMarkingGauge_MetalRuler_32.6x1.2mm.stl | 496.0KB |
