On my printer and settings, I paused at layer 26 to change the filament to a different colour.
I added a purge block stl file so you can do the same.
If using Cura slicer, first open the purge block file and then the base, your printer will start each layer on the purging block.
My settings:
Temp: 200 degrees C
Bed Temp: 50 degrees C
Speed: 50mm/s
No supports
No rafts
Skirt
Infill: 25%
| Arms_-_Mario_Kart_Stand.stl | 8.6KB | |
| Base_-_Mario_Kart_Stand.stl | 618.8KB | |
| Purge_Block_-_Mario_Kart_Stand.stl | 684.0B |
