The file 'Mario Bros Question Block Lamp 3D Printer Model' is (stl) file type, size is 50.8KB.
I really liked the original by Wiper, but I noticed the panels didn't fit and were too thick. I reduced the panel thickness to allow more light through. I updated the base to use a standard barrel style power supply and switch. The base is notched to allow the LED plug to sit flush and create a clean power plug look. I created a new lid with no question mark, it looked funny to me with a question mark on the lid. But if you like a question mark on the lid, simply print another side panel. I also created a simple cage to hold a LED strip. I originally planned on 2 rows of LED's, but decided to wrap it a 3rd time. It was bright enough with 2 rows of LED's, I was just lazy and didn't want to splice the wires :) .
I laid everything out so you will not need any supports, everything prints flat. I did use a 5mm brim on the panels, lid and top/bottom box parts. I had the base curl off the bed and didn't want to go through that again.
If I was to do it again, i would print the panels at 100% infill to get rid of the grid showing up when the LED's are on.
LED's https://www.amazon.com/Waterproof-Flexible-Daylight-Gardens-Kitchen/dp/B00HSF66JO
Power supply with switch https://www.amazon.com/AspenTek-Supply-Adapter-maxlength-Maxlength/dp/B00S1GRFYY
Question_Box_Base.stl | 57.3KB | |
Question_Box_Top.stl | 30.4KB | |
Question_LED.stl | 64.6KB | |
Question_Lid.stl | 3.5KB | |
Question_Mark.stl | 4.0KB | |
Question_Shadows.stl | 29.0KB | |
Question_Side.stl | 11.7KB |