Welcome to the 3D Printed Manual Transmission Model project! This project provides the design files and instructions to create a fully functional model of a manual transmission using 3D printing. The model demonstrates the inner workings of a real manual transmission, allowing enthusiasts and students to understand and visualize its mechanics.
| 1shifter_column.stl | 38.9KB | |
| 1st_gear.stl | 307.7KB | |
| 2nd_gear.stl | 282.9KB | |
| 2shifter_column_left.stl | 43.6KB | |
| 2shifter_column_right.stl | 46.0KB | |
| 3rd_gearR_gear.stl | 258.3KB | |
| 4th_gear.stl | 255.7KB | |
| 5th_gear.stl | 225.5KB | |
| ball_joint.stl | 408.6KB | |
| blocking_ring.stl | 116.9KB | |
| end_cap.stl | 69.4KB | |
| gear8_teeth_reverse.stl | 12.3MB | |
| Gear_dog_teath.stl | 97.4KB | |
| left_shifting_rod_connector.stl | 67.4KB | |
| long_leg.stl | 42.1KB | |
| middle_shifting_rod_connector.stl | 59.9KB | |
| motor_connector.stl | 76.4KB | |
| motor_mount.stl | 42.9KB | |
| output_wheel.stl | 1.6MB | |
| reverse_gear.stl | 820.2KB | |
| right_shifting_rod_connector.stl | 59.9KB | |
| shaft_end_support.stl | 82.3KB | |
| shaft_front_holder.stl | 60.4KB | |
| shaft_support.stl | 66.3KB | |
| shifter_assembly_holder.stl | 89.3KB | |
| shifter_knob.stl | 449.9KB | |
| shifter_middle_plate.stl | 126.7KB | |
| shifter_mount.stl | 193.1KB | |
| shifter_shell.stl | 64.5KB | |
| shifter_stick.stl | 55.4KB | |
| shifter_top_plate.stl | 81.5KB | |
| shift_fork_back.stl | 55.6KB | |
| shift_fork_front.stl | 58.5KB | |
| shift_fork_middle.stl | 58.6KB | |
| short_leg.stl | 34.8KB | |
| Spur_Gear_10_teeth.stl | 200.4KB | |
| Spur_Gear_12_teeth.stl | 225.5KB | |
| Spur_Gear_16_teeth.stl | 283.8KB | |
| Spur_Gear_18_teeth.stl | 274.6KB | |
| Spur_Gear_8_teeth.stl | 861.7KB | |
| support_leg.stl | 15.4KB | |
| synchronizer.stl | 137.0KB |
