Manual Rolled Label Despencer 3D Printer Model
The file 'Manual Rolled Label Despencer 3D Printer Model' is (stl) file type, size is 15.6MB.
The file 'Manual Rolled Label Despencer 3D Printer Model' is (stl) file type, size is 15.6MB.
I work in an environment that requires me to use roles of labels to stick to various Items.
have been just putting the roll on the table and pulling labels off as needed. i was constantly
pushing the rolls back as i unroll the labels.
this part works great. just put a roll of labels on the rod in between 2 of the Label dividers and put a spring clip on the outside of each divider to hold it in place.
This will accommodate a roll that's up to 14 inches in diameter and 4.5 inches wide.
| Label_divider.stl | 49.3KB | |
| Label_Holder_Body.stl | 385.6KB | |
| M18_Nut_RT.stl | 24.9MB | |
| Spring_Clip.stl | 40.5KB | |
| Threaded_rod_for_label_holder.stl | 7.7MB |
