Manual Feeders: Complete System 3D Printer Model
The file 'Manual Feeders: Complete System 3D Printer Model' is (stl,7z) file type, size is 5.0MB.
The file 'Manual Feeders: Complete System 3D Printer Model' is (stl,7z) file type, size is 5.0MB.
A BASE. Please use M3*8 bolts, spring washers and hex nuts to fix rails to the base, to make the system portable. IPT included.
HIGHER VERSIONS OF ALL 3 CARTRIDGES. Heights increased by 5mm. SLDPRT included.
CARTRIDGE PRINTING DIRECTIONS
Print flat. No support. Fan on high. Solid infill. Finest settings. Clean up with xacto knife.
Manual Feeders: The Complete System is printable on a 200*200 format. Split models as needed.
Do not tighten the rail screws with excessive force. Otherwise you may squash or crack prints. Did I mention spring washers?
Use pre cut stickers to label. You can buy those in sheets of 500. If you have a label maker, that's fine.
Credits to the awesome people who published the original models.
FURTHER WORK NEEDED Improve the fitting.
| Base.stl | 77.2KB | |
| Feeder.7z | 5.0MB |
