Here's a filament holder to show off your maker pride! One side says "Heart of a Maker," and the other side says "Make Your Heart Out." This five-piece model holds a regular 1kg filament spool.
Here's the story:
As soon as I saw this challenge I was inspired to make a filament holder celebrating makers! The challenge for me was designing one that would print on my Printrbot Play, which has a build dimension of 10x10x13 cm, which is too small to make a two-piece standard-sized filament holder. So I tackled my printer constraints by designing a multi-piece holder with pieces that fit nicely into each other. I designed it in Tinkercad.
My design incorporates printability on a small printer and maker swag!
The filament holder in the images is blue 1.75mm PLA.
| filament_holder_cylinder_and_end.stl | 11.2KB | |
| filament_holder_end_holder_for_cylinder.stl | 4.8KB | |
| filament_holder_flat_bottom.stl | 34.4KB | |
| filament_holder_heart_of_a_maker_side.stl | 128.8KB | |
| filament_holder_make_your_heart_out_side.stl | 137.8KB | |
| filament_holder_whole_thing_DEMO_ONLY.stl | 316.9KB |
