Check it out: https://www.thingiverse.com/thing:2860825
I print this 60% infill, no supports no rafts, 2 perimeters and -0.06mm horizontal correction (for added spacing)
Print everything flat on the bed. Especially the screw :) so that the strength follows the grain of the printer part.
Check out Modular Arm Helper
https://www.thingiverse.com/thing:2860825
| mah_gripper_v2_body.stl | 75.8KB | |
| mah_gripper_v2_feng.stl | 21.7KB | |
| mah_gripper_v2_flexblock1.stl | 1.4KB | |
| mah_gripper_v2_flexblock2.stl | 1.4KB | |
| mah_gripper_v2_screw.stl | 471.7KB | |
| mah_gripper_v2_setblock.stl | 1.4KB | |
| mah_gripper_v2_thread.stl | 843.6KB |
