Changed the design slightly for my cr10. Can be used with or without magnets. Was going to make a clip on version but then it would be limited to the cr10/wanhao control boxes. Highly recommend printing the rod as will for stability.
Uses 4x 608ZZ bearings(standard skate bearings)
Magnets are 1/4 x 1/8 and my specific ones were bought here:
https://totalelement.com/collections/all-discs/products/1-4-x-1-8-inch-neodymium-rare-earth-disc-magnets-n48?variant=27079837061
| nut.stl | 1.5MB | |
| screw.stl | 1.5MB | |
| side1.stl | 38.1KB | |
| side2.stl | 38.5KB | |
| spacer.stl | 57.2KB | |
| stability_rod.stl | 1.1KB | |
| tire.stl | 223.1KB |
