Magnetic Sewing Strap 3D Printer Model
The file 'Magnetic Sewing Strap 3D Printer Model' is (stl) file type, size is 50.7KB.
The file 'Magnetic Sewing Strap 3D Printer Model' is (stl) file type, size is 50.7KB.
This is a magnetic strap (135 x 15 mm, or 5.3 x 0.6 inches in þe olde unitſ) that lets you loosely roll-up your project's excess fabric and hold it together conveniently. You can stick your needle to it as well.
You will need two 8 x 5 mm neodymium magnets for each strap. They're about 10 cents each on AliExpress, search for "round magnet 8x5".
To install the magnets: Stick two of them together and mark the opposite sides of the stack with a pen. Separate the magnets (these magnets are very strong, so the easiest way is to "cut" between them with a knife and carefully slide the magnets off the blade). Press the magnets into the holes with the marked sides facing down. I used a small vice to press them in, but you can tap them in with a rubber mallet and a dowel. Do not use any glue.
| magnet_strap.stl | 192.9KB |
