https://www.youtube.com/shorts/YY9djICMJGI
You can disable this latch by sliding the red lever up into the lock position (don't tighten the screw too tight)
Required:
- 2 x screws per latch 4x25mm drywall screws work well
- 1 magnet per latch - diameter 8mmx5mm long (will accept longer)
- superglue
1 magnet per key (REQUIRES 10mm diameter !!!) - the smaller ones don't stick well to the drawer
Installation
- align the latch assembly with the top of the inside of the drawer not touching the front of the drawer (must still move freely)
- with the latch installed and in the dropped position, close the drawer to a point where you can mark the side of the cupboard where the approximate center of the pin would be
- Remove the drawer
- on the inside of the cupboard, install the pin approximately 25 - 28mm from the front edge
