magnetic chess set made to print on the original Prusa MK3
Round magnets needed:
(x3) 8-10 mm long x 6 mm
(x96) 5-6 mm long x 4 mm
i bought these cheap from gearbest-takes a while though to arrive
glue will also be needed but i wouldnt recommend super glue that binds in 10 sec.
i used a superglue gel that took 30sec to bind.
be very careful that every magnet is the right way round. 1 mess up and u willl have to start all over with printing and buying magnets
pls do test prints with the chess plates i printed them at 101% size
the holes on the chess board have a nice fit for the 4mm round magnets so that u can push them nicely in without them falling deeper in the hole. i pushed these magnets with my finger nail 1mm down to decrease the magnet strengh i then put glue on top of them and i placed the plates(Tiles) on top.
the holes in the chess pieces are slightly too large which makes it harder to glue them in maybe decreasing the size to 99% might help make the holes tighter. dont put the pieces to close together when the glue is binding the magnets could move by them self.
| bishop_hole.stl | 12.5MB | |
| CHESSBOARD.stl | 394.4KB | |
| chess_outsideL.stl | 2.4MB | |
| chess_outsideR.stl | 2.4MB | |
| chess_outside_small_parts.stl | 514.0KB | |
| chess_outside_small_partsV2.stl | 63.3KB | |
| chess_plate.stl | 684.0B | |
| horse_hole.stl | 7.2MB | |
| king_hole.stl | 16.0MB | |
| pawn_hole.stl | 6.8MB | |
| queen_hole.stl | 14.1MB | |
| rook_hole.stl | 9.8MB |
