This is a cable holder with 2 magnets inside.
The diameter of the magnets is 8mm with a hight of 1mm.
You have to put one magnet inside the mount and glue it from the back to a surface.
Then from the front you can see no magnet - only through the 0.2mm thin PLA cover layer.
The other two pieces you have to put around a 4mm cable.
Use a little bit of glue between the "ZicZac" area to fix it permanently.
Oh, and don´t forget to glue on the second magnet ;)
Have fun :)
| Magnetic_Cable_Holder_complete.stl | 105.9KB | |
| Magnetic_Cable_Holder_female.stl | 15.9KB | |
| Magnetic_Cable_Holder_male.stl | 40.3KB | |
| Magnetic_Cable_Holder_mount.stl | 49.9KB |
