These are magnetically actuated drawer locks.
Items needed:
8mmx3mm magnet gets pressed into slot in 'Lever'
3/16"x1/16" magnet gets pressed into slot on bottom of 'Housing'. Make sure you orient this so it pushes the lever up. There's a hole on the opposite side to push the magnet out if needed.
3/4"x3/8" magnet used to unlock -- just put in front of the lock on the outside of drawer (seen in 4th picture)
1.58"x1.58" 3M mounting pads to stick the housing to the inside of drawer -- cut a hole or leave backing on area where the 'Lever' contacts the adhesive.
To stick the 'Catch' cut a piece of adhesive pad to size.
The catch mounts on the bottom of the drawer hole in the cabinet. Line it up in the center, stick it, then mount the lever/housing assembly high enough so the lever will snag on the catch.
| All_parts.stl | 257.0KB | |
| Catch.stl | 2.0KB | |
| Housing.stl | 199.4KB | |
| Key_Bottom.stl | 88.6KB | |
| Key_Top.stl | 520.9KB | |
| Key_Washer.stl | 38.2KB | |
| Lever.stl | 55.7KB |
