Magikis Fabrikis 0.7 – H-Bot 3D Printer For Under $300 3D Printer Model
The file 'Magikis Fabrikis 0.7 – H-Bot 3D Printer For Under $300 3D Printer Model' is (dwg,stl) file type, size is 277.7KB.
The file 'Magikis Fabrikis 0.7 – H-Bot 3D Printer For Under $300 3D Printer Model' is (dwg,stl) file type, size is 277.7KB.
THIS IS STILL A WORK IN PROGRESS
More info will be added later
Basics:
-H-Bot setup
-Uses fishing line/thread
-Open Source
-Easily scalable
-Easy to build
-Cheap
Vitamins:
-M4x10 Button screws (x49)
-M4 Nuts or T-Nuts (x49)
-210mm Aluminum Extrusion (x4)
-240mm Aluminum Extrusion (x4)
-209.5mm Aluminum Extrusion (x1)
-330mm Aluminum Extrusion (x4)
-140mm Aluminum Extrusion (x1)
-Nema17 Motor (x4)
-240mm Threaded rod of choice + flange nut (x1)
-608 Roller bearing (x6)
-Fishing line or other strong thread
-M3x8 Socket Head Cap Screw (x16)
-M3x18 Sock Head Cap Screw (x5)
-M3 Nut (x5)
-Spring (x3)
-625 Roller Bearing (x1)
-1.75 PTFE Tube [At least 50cm length] (x1)
-Controller board of your choice
-Power supply of your choice
-Hot end of your choice (PEEK recommended (Examples: Printrbot Ubis hotend, Geeetech PEEK hotend). E3D + more support to be added later)
| Back.dwg | 30.0KB | |
| Bearing.stl | 71.2KB | |
| Bed.dwg | 22.2KB | |
| Bottom.dwg | 26.8KB | |
| Corner.stl | 25.6KB | |
| CornerLoose.stl | 25.5KB | |
| ExtruderArm.stl | 241.7KB | |
| ExtruderArmHalf.stl | 90.9KB | |
| Front.dwg | 41.5KB | |
| HotendHolder.stl | 398.0KB | |
| MotorMountExtruder.stl | 323.9KB | |
| MotorMountLeft.stl | 258.5KB | |
| MotorMountRight.stl | 257.8KB | |
| MotorMountZ.stl | 219.5KB | |
| Side.dwg | 30.9KB | |
| TableHolderBack.stl | 130.1KB | |
| TableHolderFront.stl | 68.4KB | |
| YSlider.stl | 129.1KB | |
| ZDrive.stl | 156.9KB |
