Magic Band / Apple Watch Minnie Charm 3D Printer Model
The file 'Magic Band / Apple Watch Minnie Charm 3D Printer Model' is (stl) file type, size is 173.6KB.
The file 'Magic Band / Apple Watch Minnie Charm 3D Printer Model' is (stl) file type, size is 173.6KB.
This is a charm designed to go on Magic Bands. I believe it will work on Apple Watch bands as well, but we don't have one to try it on.
Use a flat head, fine thread computer screw to attach it to the band. I think this is a 5mm M3 screw. I've included the type of screw I used in one of the pictures. I'm guessing other computer screws would work as well. I just haven't tried them.
The print is so small that I got a little stringing inside the screw hole. Clean that out by just twisting a knife around in there a few times.
The hole is not threaded. But, you can use a little pressure to get it started on the screw and it should thread right on. If you tighten it down too far, you'll get a dimple on the face of the charm from the screw trying to push through.
I found the 0.16 Dynamic Quality profile in Cura gave the best results for me.
| Apple_Watch__MagicBand_Minnie_charm.stl | 488.2KB |
