MagHex Holder
All my MagHex prints were getting messy, so I made this to keep it organized.
Features
- Holds all your MagHex Tiles and tops together and keeps them organized
- Each stack holds 50 MagHex tiles, or ~150 tile tops
- Uses just a few rubber bands to hold everything together. (no magnets, sadly)
Notes
- Stacks print in vase mode ("Spiralize Outer Contour" in Cura). Set "bottom thickness" to 2mm to print the base solid.
- Takes a minimum amount of filament and time. About 70g for each Endcap and 240 for the Case.
Changelog
03.19.2020
- Huge redesign of this thing.
- Made the Endcaps deeper to hold the stacks better
- Made the Case optional in the design to save filament
06.03.2019
- First upload of the design.
