I needed a M8*10mm bolt, washer and nut and decided to make them in different lengths as well as threaded rods, spacers, standoffs in case I need them later.
I printed them with 0.2 layer height, they aren't loose or tight and works quite well.
| m8_100mm.stl | 2.1MB | |
| m8_10mm.stl | 272.5KB | |
| m8_20mm.stl | 490.6KB | |
| m8_30mm.stl | 817.8KB | |
| m8_40mm.stl | 948.8KB | |
| m8_50mm.stl | 1.1MB | |
| m8_60mm.stl | 1.6MB | |
| m8_70mm.stl | 1.7MB | |
| m8_80mm.stl | 1.8MB | |
| m8_90mm.stl | 2.0MB | |
| m8_spacer_25mm.stl | 580.5KB | |
| m8_spacer_25mm_not_throughhole.stl | 500.1KB | |
| m8_spacer_50mm.stl | 1.1MB | |
| m8_spacer_50mm_not_throughhole.stl | 939.7KB | |
| m8_threadedrod_100mm.stl | 2.1MB | |
| m8_threadedrod_10mm.stl | 351.4KB | |
| m8_threadedrod_20mm.stl | 513.2KB | |
| m8_threadedrod_30mm.stl | 807.0KB | |
| m8_threadedrod_40mm.stl | 938.1KB | |
| m8_threadedrod_50mm.stl | 1.0MB | |
| m8_threadedrod_60mm.stl | 1.6MB | |
| m8_threadedrod_70mm.stl | 1.7MB | |
| m8_threadedrod_80mm.stl | 1.8MB | |
| m8_threadedrod_90mm.stl | 1.9MB | |
| nut_1.stl | 220.4KB | |
| nut_2.stl | 127.7KB | |
| standoff_15mm_10mm_f.stl | 501.2KB | |
| standoff_25mm_10mm_f_.stl | 490.4KB | |
| standoff_25mm_20mm_f.stl | 952.7KB | |
| standoff_50mm_20mm_f.stl | 950.2KB | |
| washer.stl | 14.9KB |
