This is a remix from the keymod rail. It is a 7 inch M-Lok.
I would recommend printing it in ABS with 50% or more infill if you want it to be impact resistant.
100% infill abs won't even dint when receiving a bb (edges might dent a little)
20% infill abs will dent a little, but this rail design makes it not too impact resistant on the M-LOK slots, so you should go higher than 20%.
PLA will be impact resistant enough at high infills, but it'S too brittle and can actually break when receiving a bb (it won`t dent, due to PLA being to brittle. It'll simply break)
Comment for other handguard/ rail designs, or for longer/ shorter versions of this M-Lok rail.
How to install:
Screws directly on the upper receiver. If it's hard to screw, simply add some grease (I added White Lithium Grease)
Made in Blender.
| tubular-MLOK.stl | 334.1KB |
![Male Regulator Cap [1/2 NPS -14 Thread] 3D Printer Model](https://res.3axis.co/a0abfa41-b681-4972-865e-dcc10df663f1/images/f0ef2d60-a447-4831-bc64-d5a81daf8e9e_thumb.jpg)
