This is a work in progress. It is the side door for a Panasonic Lumix GX-8. It does not have the retainer loops, I can't figure out how to print them well or to install the loops without significant disassembly of the camera. My strategy is to print several (one file has a 5x set) and put in a new one if the old one is lost. They take about 20 minutes and very little filament to print.
Notes:
1) I did not round 2 of the corners in the design, but did so physically after printing with sandpaper.
2) I used PLA to print, but a more rubbery filament would probably be better.
3) This cover is NOT water proof/resistant, but should keep out most dust.
UNIQUE SETTINGS
Cura Super Quality
Infill Pattern grid
Infill Density 15%
Connect Infill Lines True
Infill Line Distance 4
Printing Temp 215 (PLA)
Top/Bottom Thickness 1.4
| LumixGX8AccDoor01a.txt | 177.0B | |
| LumixGX8AccDoor01d.3mf | 125.1KB | |
| LumixGX8AccDoor01d.stl | 88.4KB | |
| LumixGX8AccDoor01d19m.gcode | 134.0KB | |
| LumixGX8AccDoor01d_x5-1h33m.gcode | 626.7KB | |
| LumixGX8AccDoor01d_x5.3mf | 267.0KB |
