This is my conversion of Kitwallace's "Loxodrome" OpenSCAD design into a desk lamp.
This "impossible" print was done on a consumer FDM printer. I'll show you how!
An updated design of this lamp has been published on Instructables
| EXPERIMENTAL-loxodrome_meshmixed.stl | 11.0MB | |
| joint.stl | 92.8KB | |
| loxodrome.stl | 5.5MB | |
| LoxodromeLamp.scad | 30.1KB | |
| magnet_gear.stl | 184.8KB | |
| magnet_ring.stl | 921.1KB | |
| plug.stl | 108.8KB | |
| shaft_clip.stl | 152.3KB | |
| shelf.stl | 156.2KB | |
| shell.stl | 977.4KB | |
| top.stl | 412.7KB |
