Low Voltage Electrical Connector 2-pin Power Block 3D Printer Model
The file 'Low Voltage Electrical Connector 2-pin Power Block 3D Printer Model' is (stl) file type, size is 9.6KB.
The file 'Low Voltage Electrical Connector 2-pin Power Block 3D Printer Model' is (stl) file type, size is 9.6KB.
More Power !!!
Yes... Yes you can, this is a simple rail buss like power strip that uses the 2-pin plug listed here
https://www.thingiverse.com/thing:3105119
LOL .. I'm so cheap!
FDM PRINTER NOZZLE SIZE 0.25 MAXIMUM
This can be of course daisy chained as i left openings on the ends.. Depending on your needs and how you wish to wire them up.
A.) Can be a two rail system to distribute power (Long Ways).
B.) Can be a simple stand alone termination block to connect other components (Short Ways).
C.) Can be a buss to plug in wires from components (All Ways).
Mix and match the male and female clips to polarize some or all the sockets as you see fit..
Male and Female Crimp Connectors:
6mm x 2.5mm x 14mm (3/16 16-18)
I used paperclips cut and bent 'U' shaped and soldered into each of the clips..
NO CRIMPING !!
CRIMPING BAD !!
PSSSST!!!! im working on another plug, as i get AROUND to it.... ;)
| terminal_block-Cut040.stl | 14.7KB | |
| terminal_block-Cut041.stl | 23.3KB | |
| terminal_block-Cut042.stl | 23.3KB |
