Low Profile Creality K1 K1C K1-Max Lid Riser 3D Printer Model
The file 'Low Profile Creality K1 K1C K1-Max Lid Riser 3D Printer Model' is (stl) file type, size is 24.8KB.
The file 'Low Profile Creality K1 K1C K1-Max Lid Riser 3D Printer Model' is (stl) file type, size is 24.8KB.
Low Profile K1 and K1 Max lid Riser. Two parts (4) corners, and (4) Edges. Nothing special required. Just print and pressure fit onto the edges of the lid to raise it up the small amount needed for the stock tube to stop scuffing the lid.
You can easily cut the edges if you want different sizes. You will also need to snip a bit of one edge for the filament notch as shown in the picture.
There's also spaces for 6mm x 2mm round magnets in the corners if you want. Again these are pressure fit, but you can use glue too if needed. I used pressure fit the magnets and it's worked for me. Also this works fine without the magnets if you don't have any.
Made mine in Space Grey PETG, but really doesn't matter, any filament can be used.
This riser saves filament, gets the job done, and is sleek. Enjoy.
| K1-LP-Riser-Corner.stl | 75.7KB | |
| K1-LP-Riser-LongEdge.stl | 79.2KB |
