All prints work and if printer is set up well no supports needed, but I would recommend supports on Loungefly2.0 V1 and V2 over 80% angle
| Loungefly2.0_tink_v1.stl | 4.2MB | |
| Loungefly2.0_v1.step | 56.8KB | |
| Loungefly2.0_v1.stl | 98.2KB | |
| Loungefly2.0_v2.stl | 123.1KB | |
| Loungefly_Hanger_V1.step | 75.4KB | |
| Tink_loungefly_2_v2.stl | 4.5MB |
