This project is an upgrade to my previous lightbar work. It extends the edges of the lightbar to make for more comfortable printing with a printer at eye level, adds 2 new sizes (200mm and 100mm) for use with smaller print beds and printers, introduces a new fully enclosed lightbar mount for use with these extrusion slot covers (http://www.mcmaster.com/#catalog/122/1939/=14feq5y) to run wires from the lightbar to the frame edges fully concealed, and also adds my corner reinforcement covers, which are designed for use with a Taz, but should fit almost any square 20mm extrusion design corners to aid in wire routing from the extrusions to the control box area.
Update 1: New 4.5 variant endcaps and mounts are larger for routing wires easier.
| back_lcd_cover_1_0_a.stl | 59.9KB | |
| left_rear_cable_cover_1_0_a.stl | 60.0KB | |
| lightbar_200mm_4_0_a.stl | 29.4KB | |
| Lightbar_305mm_4_0_a.stl | 32.1KB | |
| lightbar_97mm_4_0_a.stl | 22.3KB | |
| Lightbar_Center_light_bracket_1_0_a.stl | 48.8KB | |
| lightbar_enclosed_ends_4_0_a.stl | 158.9KB | |
| lightbar_enclosed_ends_4_5_a.stl | 130.6KB | |
| Lightbar_endcap_4_0_a.stl | 47.8KB | |
| Lightbar_endcap_4_5_a.stl | 115.0KB | |
| right_rear_cable_cover_1_0_a.stl | 60.0KB |
