A nice little quick and simple light up snowman ornament. The hat is in two parts and is intended to be connected over-top a string light, and then snapped onto the snowman body, causing a nice glow from the refracted light.
No supports needed. Start by measuring the size of your lights, as scaling may be required. Print two halves of the hat, 4 pins, and 11 buttons to be used in any of the locations with an indent for them in the body. May be easier to just mark them with a sharpie since these parts will be very small. The scarf doesn't need any support, just print it upside down and glue the two halves to the body. Measures about 3.5 inches in height.
This idea came to me after making my UFO ornament with a similar snap-over-light design seen here: https://www.thingiverse.com/thing:6392970 This time trying to fit the theme a liiiitle better.
Designed in Catia
| sm_light_body.stl | 15.9MB | |
| sm_light_button.stl | 212.8KB | |
| sm_light_hat.stl | 1.2MB | |
| sm_light_nose.stl | 83.5KB | |
| sm_light_pin.stl | 2.5KB | |
| sm_light_scarf_1.stl | 351.0KB | |
| sm_light_scarf_2.stl | 88.2KB |
