Only printed parts, a few screws and some glue are needed.
Prints completely without supports.
I printed it in PETG but other materials will work.
It is not difficult to print.
Some of the parts need to be printed several times. See file names.
If there is a x4 in the filename, you need to print this part 4 times.
Please check the screen shot I took from the slicer print bed view. You can see all the needed parts and also the orientation, which side needs to be on the top while printing.
There is file with quite few instructions for assembly. Unfortunately PDF is not a supported file format here. So I exported it into a PS file. This should work for most people, I guess. I have now add the assembly instructions as Jpg files in the Post-Printing section. Please look there.
I have included the 3D model as a STP file as well. Feel free to use it.
| lifting_table.stp | 1.5MB | |
| lifting_table01.stl | 24.5KB | |
| lifting_table02.stl | 24.9KB | |
| lifting_table03_x4.stl | 12.2KB | |
| lifting_table04_x4.stl | 32.5KB | |
| lifting_table05_x2.stl | 32.3KB | |
| lifting_table06_x2.stl | 35.8KB | |
| lifting_table07.stl | 33.3KB | |
| lifting_table08.stl | 35.2KB | |
| lifting_table09.stl | 29.0KB | |
| lifting_table10.stl | 30.7KB | |
| lifting_table11.stl | 203.3KB | |
| lifting_table12.stl | 29.5KB | |
| lifting_table_assembly.ps | 7.9MB |
