Life (or Anything) Counter For Table-top Games 3D Printer Model
The file 'Life (or Anything) Counter For Table-top Games 3D Printer Model' is (stl,txt) file type, size is 521.6KB.
The file 'Life (or Anything) Counter For Table-top Games 3D Printer Model' is (stl,txt) file type, size is 521.6KB.
This is an original life (or points or arrows or anything) counter for games like D&D or Magic the Gathering.
IMPORTANT NOTE: I recommend printing the 'all except tube' variation in one print, then printing the tube by itself because it's the most likely to fail in my experience. The other files are included for your convenience. If you have trouble printing the tube, try it with a raft and/or supports.
Like my work? Check out my Patreon page: https://patreon.com/scottreece
2019-08-20 edit: I just added 2 updated files: Number-only-OPTIONAL.stl and Two-rings-clip-and-tube-OPTIONAL.stl. Both were uploaded earlier, but had some problems. The scales were off by 100x and the tube was missing.
| Life_Counter_V1.00-all.stl | 637.8KB | |
| Life_Counter_V1.00-all_except_tube.stl | 625.1KB | |
| Life_Counter_V1.00-clip.stl | 22.3KB | |
| Life_Counter_V1.00-one_ring.stl | 111.9KB | |
| Life_Counter_V1.00-one_spring.stl | 73.1KB | |
| Life_Counter_V1.00-sides.stl | 49.1KB | |
| Life_Counter_V1.00-three_rings.stl | 335.2KB | |
| Life_Counter_V1.00-three_springs.stl | 218.7KB | |
| Life_Counter_V1.00-tube.stl | 12.8KB | |
| Number-only-OPTIONAL.stl | 94.1KB | |
| test.txt | 60.0B | |
| Two-rings-clip-and-tube-OPTIONAL.stl | 41.1KB |
