Life Counter For MtG With Click Positions And Snap Together Construction 3D Printer Model
The file 'Life Counter For MtG With Click Positions And Snap Together Construction 3D Printer Model' is (stl) file type, size is 246.9KB.
The file 'Life Counter For MtG With Click Positions And Snap Together Construction 3D Printer Model' is (stl) file type, size is 246.9KB.
Created new, thinner caps with a decagon post and a cut on the edge to prevent the life counter from tipping. Removed the screw, opting instead for a snap fit construction. The fit is very secure. Glue should not be necessary, but may be used if desired. The numerical rotors are unchanged from bridge2nowhere's version.
Acrylic paint was used to make the arrows and numbers pop from the prints.
Print
1-v1_Cap.stl
1-v1_Cap_w_post.stl
2-v1_Rotor.stl
At the suggestion from reddit I added a post file for a 3 digit design.
Print
1-v1_Cap.stl
1-v1_Cap_w_post_for_3_rotors.stl
3-v1_Rotor.stl
If the number rotors do not click well on v1, try using v3 Cap and v3 cap w post.
| v1_Cap.stl | 131.0KB | |
| v1_Cap_w_post.stl | 131.4KB | |
| v1_Cap__w_post_for_3_rotors.stl | 134.6KB | |
| v1_Rotor.stl | 72.9KB | |
| v3_Cap.stl | 711.0KB | |
| v3_cap_w_post.stl | 137.1KB |
