two winglets for LIDL glider version2
They fit perfectly to the tips of the wings and do not prevent (pre cut) ailerons to move.
To get enough strength I printed them with 2 perimeters, 0% infill, 0 bottom layer and 0 top layers
Note that If you want lighter print then use a single perimeter (or spiral vase). This may need to scale down just a little the models.
Don't print them in PLA or they may not resist to sun in summer... Prefer PETG or PET.
They print vertically without supports
| WingletV2Left.STL | 174.0KB | |
| WingletV2Right.STL | 174.0KB |
