This lid can be handy if you don’t finish your drink. It is not completely air and water tight, but it is nice when handling your drink or if you put half a can in the fridge.
Do not use infill higher than 10% on PLA. This will keep the lid flexible, so it is easy to get it of the can. There are two versions. One with a small brim for easy opening. It can be printed without support.
The lids on the picture are made in red (RFPLCXEU0JB) and neon green (RFPLCXEU0AD) PLA on my DaVinci Jr. The print quality were set to “Normal” without any alterations from the standard (10% infill, 0.3 mm layer height, no support, etc)
| DoNot.stl | 161.3KB | |
| Lid.stl | 634.8KB | |
| Lit_b.stl | 654.3KB |
