Liberator AR-23 Helldivers 2
Note
This is my first time modeling something from scratch, printing, and posting on Thingiverse. This is not a perfect 1:1 model, but I did my best. I will answer any questions and would love constructive criticism and or feedback.
Trigger Housing
This is a modified housing from the "Helldivers 2 P4 Revolver functional prop" by CosmicForge
The fit into the handle is snug with my printer, may be necessary to scale down slightly if problems arise for you specifically.
For it to function they recommend the following, however the model is slightly scaled up from the original. I used an imperial bolt and cut it to fit.
-(1) M3 x 20mm bolts
-(1) ¼"x7/8" extension spring
Magazine and Body C
-(4) 6x3mm magnets
Charging Handle
I originally designed it to be spring-loaded, however, it was a pain to set up in such a tight space. For simplicity, I removed the spring mechanism and left it to slide freely. If there is anyone interested in the spring version, I could post that too. Just make sure to place the Handle inside before you start gluing pieces together.
Scope
The scope was intentionally designed to slide with plenty of clearance for easy removal or gluing. If you are interested in a snug fit, try scaling down ~1-2%, though I have not tested this.
| Body_A.stl | 134.4KB | |
| Body_B.stl | 997.6KB | |
| Body_C.stl | 109.6KB | |
| Bottom_Rail.stl | 35.5KB | |
| Charge_V2.stl | 11.9KB | |
| Cube_x2.stl | 684.0B | |
| Handle.stl | 108.8KB | |
| Magazine.stl | 229.2KB | |
| Scope.stl | 570.0KB | |
| Stock.stl | 140.5KB | |
| Top_Rail.stl | 50.2KB | |
| Trigger.stl | 63.0KB | |
| Trigger_Housing_A.stl | 16.3KB | |
| Trigger_Housing_B.stl | 16.3KB | |
| Trigger_Spring_Pin.stl | 72.9KB |
