BETTER PICTURES WILL COME!

The Li3D Light is a very compact 3 led light for the Duplicator i3 printer.
It's very useful when printing at areas with poor light condition, and at the same time providing very little blockage of the view of the part being printed.

Works great together with the CiiiCooler

[CHOOSING THE RIGHT PARTS]
V1.0 and V2.0 - LeeeD_Light_Cover_1-1 and LeeeD_Light_Holder_TypeA_1-1
V2.1 - LeeeD_Light_Cover_1-1 and LeeeD_Light_Holder_TypeB_1-1

[REQUIRED HARDWARE]
1 pcs LED Board Strip (Use the white section after breaking off)
2 pcs M3x8 screw or longer (For V1.0 and V2.0 machines)
2 pcs M3x14 screw or longer (For V2.1 machines)
2 pcs M3 nut (or locknut)
Cables, connectors and soldering skills.

[MOUNTING INSTRUCTIONS]
0) Clean up the parts from the skirt and vertical supports of the cover.
1) Solder wires to the PCB of appropriate length for your printer. (Preferably too long and cut later to size)
2) Place the LED board with the back into the holder in the slot shown on the assembly picture.
3) Route the wires according to the assembly picture.
4) Place the cover ontop of the LED board assembly picture.
5) Place nut into nut socket and fasten with the screws through the mounting bracket of the printer.
6) Make sure the LeeeD light is wired in parallell with the extruder fan (always on).

[ATTENTION]
If you short-circuit any part of this assembly you might fry your printer. Please be careful. You have been warned!

[DONATIONS]
If you find that the item improve your daily life, consider supporting the designer by sending a tip.
Click "TIP DESIGNER" here.