Levoit LV-H132 Duct Adapter 3D Printer Model
The file 'Levoit LV-H132 Duct Adapter 3D Printer Model' is (stl) file type, size is 158.8KB.
The file 'Levoit LV-H132 Duct Adapter 3D Printer Model' is (stl) file type, size is 158.8KB.
I needed a way to safely vent the fumes from my enclosure and realised that my old air purifier would be perfect as it has both a HEPA filter and an active carbon filter.
This set replaces the bottom cover for the air purifier with a conical adapter that goes down to a standard air pipe (95mm-ish inner diameter) and comes with a stand to prop the air filter up with.
This was made for the Levoit LV-H132 air purifier however it might fit others that have a diameter of 200mm (or smaller if you have enough duct tape to cover the gap)
With the adapter and the pipe sealed up, I managed to get a strong flow even on the lowest setting which is promising.
(Make sure you remove the base before installing the adapter)
The adapter is 206mmx206mmx96mm so it should fit any Ender 3 / similar in one piece.
I wouldn't recommend buying an air purifier specifically for this as it's not worth the price just to filter an enclosure's air, I made these parts as I already had the purifier on hand and it was not being used.
| 100mm_to_60mm_Adapter.stl | 200.1KB | |
| 100mm_to_80mm_Adapter.stl | 200.1KB | |
| Levoit_Air_Purifier_Stand.stl | 45.8KB | |
| Levoit_Air_Purifier_to_100mm_duct.stl | 200.1KB |
