I designed a simple and fun little device myself. Installation instructions are shown in picture.It 's very easy. I hope you like it.
Special Instructions:
The diameter of the ball must not exceed 20 mm. Print directly from the downloaded file.
(Pay attention to model contact surface with hot bed when printing)
Recommended using a lower layer hight (0.15/0.2mm) for better results in details.the colors are up to you，This model was printed using PLA.
| ball_200mm.stl | 59.8KB | |
| lever_ball_device_arm.STL | 33.8KB | |
| lever_ball_device_body.STL | 263.5KB | |
| lever_ball_device_box.STL | 33.5KB | |
| other_component.STL | 66.9KB |
