Lenovo SA120 LFF Drive Tray 3D Printer Model
The file 'Lenovo SA120 LFF Drive Tray 3D Printer Model' is (stl) file type, size is 22.3KB.
The file 'Lenovo SA120 LFF Drive Tray 3D Printer Model' is (stl) file type, size is 22.3KB.
Ready to assemble Lenovo SA120 LFF Drive tray.
Everything was printed with 20% infill with basic settings using PLA. Modeled from the ground up using a Lenovo OEM drive tray.
The handle is is not as strong as my Dell model due to the thickness of Lenovo drive trays. The handle should allow you to pull the drive in and out after you use some super glue to give it a little extra strength. All you need are 4 screws just about any should work. The handle/connector is a tight fit but may require some super glue to give it some extra strength.
I had some of these laying around from a different project: http://www.ebay.com/itm/-/180999268972
| big_side.stl | 132.7KB | |
| connector.stl | 54.0KB | |
| small_side.stl | 131.4KB |
