Had to make my own version, to get my own character on the bridge and pillars. these are Lego compatible so that it is possible to build further for different heights etc.
4 bridge frames, 2 top frames are needed. Print 2 pcs. mirror and print 2 pcs. then you have the back and the left side.
This bridge is compatible with parts from the other bridge I have.
The bridge has a span of 4 X Lego train tracks. The bridge is almost 52 cm long
It is possible to extend the span with several sections, as well as increase the width for double tracks.
In version 2, there are small changes such as a 2mm cutout on the top frame so that the clearance is 4mm above the car in the picture. and that the thickness of the bridge frame has been increased from 6 to 7 mm and extended the nobs on top to 3mm
Fra Norge kan brikker kjøpes her: https://brikkebutikken.no/
godt utvalg og rask å sende
| 5x16x5_Bridge-Pillar-stone.stl | 2.4MB | |
| Bridge-Frame-mid-half-V2.stl | 944.6KB | |
| Bridge-Frame-mid-Large-V2.stl | 981.7KB | |
| Bridge-Frame-V2.stl | 2.9MB | |
| Half-mid-ext-section-dobbel-track.stl | 1.5MB | |
| Half-mid-section-dobbel-track.stl | 2.4MB | |
| Top-Frame-mid-half-V2.stl | 1.5MB | |
| Top-Frame-mid-large-V2.stl | 2.8MB | |
| Top-Frame-V2.stl | 1.9MB |
