Legacy Hotend CR10(s)/Ender3 Direct Drive 3D Printer Model
The file 'Legacy Hotend CR10(s)/Ender3 Direct Drive 3D Printer Model' is (stl) file type, size is 3.7MB.
The file 'Legacy Hotend CR10(s)/Ender3 Direct Drive 3D Printer Model' is (stl) file type, size is 3.7MB.
LEGACY Direct Drive
This is a further development of the Omega direct drive system design.
Its been made for little, to no support option .
Rotate the parts yourself for minimal support setting.
It will fit the CR10(s) and ender3 (well, all printers with the same X carriage system).
This hotend assemble is only for use, with the Bondtech BMG extruder, and stock hotend
(or microswiss)
The stock NEMA 17 stepper motor should fit on fine
(but it will stick futher out from the frame)
Im using a smaller 25mm stepper motor on this design.
Only BLTouch autolevel system is featured in this design (because, thats what i use)
If the cover is a bit loose, then add some tape on the inside, to minimize the gap between the fan and cover.
i have also, thrown in a cable holder, that sits on the extruder stock place.
I hope you will enjoy this design :) Go make some stuff ...
| Complete_assemble_display.stl | 4.3MB | |
| Complete_assemble_explode.stl | 4.3MB | |
| Cover.stl | 47.2KB | |
| Fan_floating.stl | 325.4KB | |
| Hot_end.stl | 391.6KB | |
| Main_body.stl | 548.4KB | |
| Motor_support.stl | 52.7KB | |
| Wire_bondle_clamp.stl | 145.4KB |
