Lee Load All II (20ga) 410 Conversion Kit 3D Printer Model
The file 'Lee Load All II (20ga) 410 Conversion Kit 3D Printer Model' is (stl) file type, size is 463.5KB.
The file 'Lee Load All II (20ga) 410 Conversion Kit 3D Printer Model' is (stl) file type, size is 463.5KB.
This is a set of adapters for use on a 20ga Lee Load All II shell loader. You will need to purchase two MEC parts: 100435410 (Sizing Ring for a 410 Shell) and 8300410 (410 Wad Guide)
Parts are fit onto the Load All fairly self explanatory. Ideally used for 2.5" Shells or smaller. It can work with 3" shells but the punch rod to remove the resizing ring (when loading a primer) is an overly snug fit when used at 3".
3 Sizes of rods are included. 2", 2.5", and 3"
Bushings for smaller loads are also included in this set.
| 0.75_Shot.stl | 44.4KB | |
| 410_2.5in_Rod.stl | 86.5KB | |
| 410_2in_Rod.stl | 56.4KB | |
| 410_3in_Rod.stl | 61.1KB | |
| 410_Part_1a.stl | 83.8KB | |
| 410_Part_1b.stl | 74.5KB | |
| 410_Part_2.stl | 51.6KB | |
| 410_Part_3a.stl | 82.1KB | |
| 410_Part_3b.stl | 104.0KB | |
| 410_Part_4a.stl | 64.9KB | |
| 410_Part_4b.stl | 122.3KB | |
| 410_Part_5a.stl | 75.3KB | |
| 410_Part_5b.stl | 130.9KB | |
| 410_Part_6a.stl | 87.2KB | |
| 410_Part_6b.stl | 130.9KB | |
| 70_Powder.stl | 71.7KB | |
| 75_Powder.stl | 70.9KB | |
| 80_Powder.stl | 104.0KB | |
| 83_Powder.stl | 109.8KB | |
| 85_Powder.stl | 103.2KB | |
| 88_Powder.stl | 119.9KB | |
| 90_Powder.stl | 98.5KB | |
| Primer_Tray.stl | 55.6KB |
