This is a lamp I made to mount to the VESA 100 mount on the back on my monitor.
Uses:
3mm MDF
2 Shoulder Bolts 1/4-20 (0.375" shoulder length)
2 6-32 nuts
2 6-32 1/2" Bolts
4 4mm Bolts (For the VESA mount)
1 50cm RGB LED strip (From Aliexpress I will have to find link but it is a standard one)
the only change I need to make is change the 6-32 to 4-40. the nuts are to close to each other and I can only use 1 in each mount. it does hold just fine but 4-40 would look better too.
NOTE: THE LED IS NOT THAT BRIGHT
I would suggest finding a brighter setup and remixing the idea to fit a better strip.
I am up for recommendations on which one to use as I will need a a few new strips.
-Dru
Dead Guy Products
| LED_LAMP.cdr | 55.9KB |
