Update (Oct 22): Having replaced some lights it is clear that newer LEDs are lighter but, in addition, more flimsy. A revised mount (v3) now included. I am using x3 of these lighter mounts because I noticed that (after time) the LED strip was sagging in the middle. Older / more robust fitting would be fine with just 2 mounts (imo).
The mounting screw requiring 20mm depth is accommodated in the base of the twin flying buttress supports.
A simple 45 deg off-set wall mount for an LED / fluorescent strip light. For use on a dorma ceiling or similar.
One central screw hole for light mounts provided. Two variants for use in whatever combination 1. standard mount 2. with a cut out to root a power cable behind.
With push on caps to hide the wall screws.
Minimalist but strong enough if 40% hex fill and a low fill angle are dialled in.
originally printed on a Anycubic Kobra
| Bracket-ScrewCap.stl | 23.5KB | |
| Bracket_Feed_V1.stl | 104.7KB | |
| Bracket_V1.stl | 101.9KB | |
| Bracket_V3.stl | 5.9MB |
