A svelte clip to hold down either one or two rows of standard outdoor LED strip (the kind covered in silicone).
Should print just fine on it's side with no support, provided you have good bed adhesion. I print 20 at a time on PEI.
Small enough to fit between the LEDs themselves.The hole is sized to take a #6 pan head screw.
I recommend you put them over the solder (cut) joints so as to minimize the amount of heat reaching them. I also recommend you print them in white so they're not absorbing any of the light.
They have a little bit of flex - the screw underside is 0.2mm shorter than the arm that reaches over the strip so it clamps down properly. This will cause an issue if you try and print them flat with no support as there won't be a first layer.
| 6_Weatherproof_LED_Strip_Dual_Clip.stl | 34.3KB | |
| 6_Weatherproof_LED_Strip_Single_Clip.stl | 50.7KB |
