Original found on printables.
Differences of the remix compared to the original
I made the difuser with one wall only and a cut so its easy to insert in the ring. Just leave the cut to the top and it wont be seen.
Added a 14.5mm hole to both bases to insert an on/off switch.
Rectanguler base is now a bit taller so it can fit a bluethooh led driver inside.
Made a cover to close the rectanguler base.
Only the rectanguler base needs supports
| Base.stl | 69.1KB | |
| Difuser.stl | 667.5KB | |
| Lid_for_rectanguler_base.stl | 41.4KB | |
| Ring.stl | 178.1KB | |
| Tube_Base.stl | 167.1KB | |
| Tube_Base_Lid.stl | 133.6KB |
