LED Mount Holder For Maker Select V2 3D Printer Model
The file 'LED Mount Holder For Maker Select V2 3D Printer Model' is (stl,STL) file type, size is 4.4MB.
The file 'LED Mount Holder For Maker Select V2 3D Printer Model' is (stl,STL) file type, size is 4.4MB.
I really liked the LED mount by Rexipus,
https://www.thingiverse.com/thing:1880015
But it was a little too big. I remade the tray the LED strip sits in to hold only half of it. It will still fit in his mounting bracket.
I ordered the same LED strips off EBAY, https://www.ebay.com/itm/301032417732 and then just cut the light panel down the middle legnth wise by scoring it about 10 times with a razor and then snapping it in two. The LEDs will still work and you end up with a panel half the size.
I used an M3 35mm screw and nut for the hinge and then M3 12mm screw and nut x2 to bolt it to the printer.
You need to have a rear mounted cooler fan like the Cii cooler (thats what I use)
https://www.thingiverse.com/thing:2004629
Just wire the LED up to the extruder cooling fan and you are good to go. Now I no longer have to use a flash light to see the print!
| LED_holder_small.stl | 70.9KB | |
| mounting_bracket.STL | 12.9MB |
